Greetings,
I'm running into an odd issue but I suspect I'm missing something obvious which someone will have no problems correcting me on.
I have created a new client in our development system, connected with the default SAP* user, set up an RFC destination to a test system (with an account that has authorization to access the test system) and started a SAP_ALL remote client copy.
During the copy, while I'm monitoring, I'm seeing the message "No RFC authorization in target system for process 00001". Since this is a new client, there isn't an actual user in the system at this point, and therefore no authorizations set outside what the SAP* account has by default.
I have also tried the client copy again after performing a SAP_USER client copy (which worked without issues) and using one of the users brought down during that copy which had the SAP_ALL profile. That user is also seeing the same messages in the log for the SAP_ALL client copy.
I'm wondering about the account perhaps needing the S_RFC_ADM authorization object, but I'm not sure why this message would be appearing only on some of the tables (375 of 5,292 copied so far) and not all of them. The tables aren't even from one component, but a cross section of them.
Does anyone have any thoughts? So far my research has not been too fruitful but I'm not quite ready to give up and send a message to SAP Support on this.
Thanks in advance,
Conrad Thonger